NEED TO CHANGE YOUR SIGNAL TO RESISTANCE?
Use the DRN4 or multiple range output DRN3.1 for the right resistance range.
 | | The Motor Mounted DRN4 transforms an analog, floating point or pulse width modulated signal into a resistance output. |  |  | |
| SEQUENCED RELAY OUTPUTS?
The AAR converts analog current or voltage signals into a two relay output with
a fixed or adjustable dead-band. The ATL converts an analog or current signal to a four relay output.
The DMUX multiplexes a pulse width modulated signal to sequence four or eight
relays, individually control them or operate only one relay at a
time.
 | | The AAR can sequence stages of heating or cooling, operate pumps or fans, and control the "on/off" of a variety of electrical loads. |  | |
| RESCALE OR ISOLATE SIGNALS So... your signal can't share a common
with the actuator? An AIM, AIM2 or AIM3 solves this
problem.
Re-scale signals with the ARM2 (field adjustable). Re-scale to very
small signals spans using the ISM or ISM3.
|
