INCREASE REMOTE CAPABILITIES?
Air handler doesn't have all the manual overrides the owner requires?
Add them with the following special products from ACT.  | | MPOE provides manual override of AHU
pneumatic damper motors or valve actuators. |  |
The MAO manual override is dual channel with alarm contacts
to indicate the override is in use. |
The MDO2FS allows dual overrides to fail safe to original
controller in case of power loss. |
| MDO2 provides dual channel digital
override to controlled device. |  |
ACT provides the communication link to the equipment
you want to control
or monitor. |  |
| ELECTRIC TO PNEUMATIC? PXP0/1/5/7.3 (bleed) and PXP2.3 (non-bleed) accept analog current or voltage signals and output a modulated pressure signal.
PWP0/1/5/7.3 (bleed) and PWP2.3 (non-bleed) accept pulse width modulated signals and output a modulated pressure signal.
PTS3.3 converts a floating point signal to a modulated pressure output (closed loop).
 |  | The EPC2FSB is a dual valve E/P interface ideal for controlling O.A damper
motors and valve actuators. It fails "safe" to zero air
pressure and also provides feedback when its manual override
is in use. |  |  |
| LIGHTING CONTROL
Use PHOTON4.1 and control over an RS485 network. Each PHOTON4.1
can control up to 4 G.E. RR7 relays. Install multiple PHOTON4.1's
in older panels as a replacement for outdated electronics.  |  |  | PHOTON4.1 provides a remote override to each
relay and ALL ON to each PHOTON4.1 module. |
|
